The most important tool when working with a laminate is considered to be an electrician. The cost of this device largely depends on its functionality, power and popularity of the manufacturer.
If the walls of your dwelling are made of concrete, then you will not be able to do without the use of a punch. Note that as an analogue it will not be possible to use a shock drill, which is completely not intended for upcoming work.
During the alignment of the wooden base with the help of plywood sheets, the installation of thresholds for laminate, screwing skirting boards, as well as at the initial stage of work, enormous assistance is capable of providing a screwdriver. Of course, the laying process cannot be carried out without the use of a special set, which includes wedges, brackets and bars.
When choosing a hammer that you will use when laying a laminate, you should give preference to a model whose weight lies from 500 grams to a kilogram. A slightly larger value is allowed.
The initial stage, during which the premises are measured, cannot be qualitatively made if there is no sufficient length of the roulette with the latch. The optimal roulette length is from 5 to 7 and a half meters. It is useful at the measurement stage and a construction pencil, which is often used in repair and construction work.
If you don’t have a screwdriver at hand, then a laminate tool called a reverse screwdriver is able to help help. If you can’t find such a screwdriver, you will have to use the standard crusade.
It should be remembered that the installation of interior doors should be carried out after the laminate is laid. However, if the doors are already installed, you will have to file a canvas in order to easily start laminate panels under it. To perform this task, a hacksaw with a wide canvas and small frequent teeth is excellent. The hacksaw will be able to provide irreplaceable help if there are problems with power supply. During sawing, it will not be possible to do without the use of the cushed, which allows you to accurately measure the angle of 22.5, 45 or 90 degrees. Among small necessary tools and accessories, the presence of the following is mandatory:
A drill for a perforator;
Scotch;
Dowel-gvo, the dimensions of which are 6 by 40 and 5 by 35;
Special construction knee pads that will not allow you to injure during work.